Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Liftgate Description and Operation: Operation
The power liftgate can be commanded to power open and power close by the following methods:
- An open or close command from the interior liftgate rotary switch
- An open command from the liftgate handle switch
- A close command from the liftgate close switch
- An open or close request by a signal from the keyless entry transmitter to the remote control door lock receiver
- The kicking motion of a foot and lower leg under the rear fascia - Sensor location may vary depending upon make and model, refer to owner's manual for the location of the sensors
The liftgate control module will respond to a request by commanding the liftgate latch to release the liftgate and activate the liftgate motor in the liftgate power assist actuator and raise the liftgate to the open position or to lower and cinch the liftgate closed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.