Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Column Lock Control Module Replacement
2018 Chevrolet Traverse LS, 4WDSECTION Steering Column Lock Control Module Replacement
| Callout | Component Name |
|---|---|
|
Preliminary Procedure
|
|
| 1 | Steering Column Lock Control Module Bolt - Rear [2x]
CAUTION:
Refer to Fastener Caution . Tighten 9.5 N.m (84 lb in) |
| 2 | Steering Column Lock Control Module Bolt - Side [2x] Tighten 9.5 N.m (84 lb in) |
| 3 | Steering Column Lock Control Module Procedure Program the steering column lock control module. Control Module References |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.