Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018TAHOE PPV, RWD, GAS/ETHANOLREPAIR AND DIAGNOSISGENERAL INFORMATIONRESET PROCEDURESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSK33 HVAC CONTROL MODULE: PROGRAMMING AND SETUPPROGRAMMING AN EXISTING OR NEW CONTROL MODULE
2018 Chevrolet Tahoe PPV, RWD, Gas/Ethanol
Programming an Existing or New Control Module
2018 Chevrolet Tahoe PPV, RWD, Gas/EthanolSECTION Programming an Existing or New Control Module
To program an existing or new control module, perform the following procedure:
- Install the special tool: EL-49642 SPS Programming Support Tool
- Ignition - On/Vehicle - In Service Mode
- Access SPS and follow the on-screen instructions for the control module: K33 HVAC Control Module
- Perform the SPS function: Programming
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.