Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2018TAHOE LT, 4WD, GASREPAIR AND DIAGNOSISBODY & FRAMEMIRRORSMIRROR SYSTEMREPAIR INSTRUCTIONSINSIDE REARVIEW MIRROR REPLACEMENT (WITHOUT UE1)

2018 Chevrolet Tahoe LT, 4WD, Gas

Inside Rearview Mirror Replacement (Without UE1)

2018 Chevrolet Tahoe LT, 4WD, GasSECTION Inside Rearview Mirror Replacement (Without UE1)

Fig 1: Inside Rearview Mirror (Without UE1)

Courtesy of GENERAL MOTORS COMPANY

Callout

Component Name

Inside Rearview Mirror Screw

CAUTION:

Refer to Fastener Caution .

Procedures

Remove the windshield multifunction sensor mount bracket cover. Refer to Windshield Multifunction Sensor Mount Bracket Cover Replacement .
Disconnect the electrical connector.
Adjust the mirror to the full upward position.
Loosen the set screw located at the base of the mirror.

Tighten
1.8 N.m (16 lb in)

Inside Rearview Mirror
Procedure
Slide the mirror upward off of the rearview mirror button.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.