Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018TAHOE LT, 4WD, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASIMAGE DISPLAY CAMERA SYSTEMREPAIR INSTRUCTIONSVIDEO PROCESSING CONTROL MODULE CALIBRATIONERROR CODES DURING ALIGNMENT
2018 Chevrolet Tahoe LT, 4WD, Gas
Error Codes during alignment
2018 Chevrolet Tahoe LT, 4WD, GasSECTION Error Codes during alignment
| Error Code | Cause | Possible Repair |
|---|---|---|
| 0101 Front Camera 0103 Front Camera 0201 Right Camera 0203 Right Camera 0301 Rear Camera 0303 Rear Camera 0401 Left Camera 0403 Left Camera |
Lighting Issue, Obstructed View of Target, Target Position out of Range, Poor Camera installation | Correct Lighting, Reposition Target, Verify Camera correctly installed and clean. |
| 0102 Front 0202 Right 0302 Rear 0402 Left |
Lighting Issue, Obstructed View of Target, Target Position out of Range | Correct Lighting, Reposition Target, Verify Camera is clean. |
| 0104 Front 0204 Right 0304 Rear 0404 Left |
Camera Position incorrect | Correct camera position |
| 0120 Front 0220 Right 0320 Rear 0420 Left |
NTSC error detected | Verify camera electrical connection |
| FFF0 Passenger Door FFF1 Left Rear Door FFF2 Right Rear Door FFF3 Driver Door FFF4 Trunk FFF5 Hood FFF6 Liftglass |
Hood, Door, Liftgate, Trunk or other part of car OPEN | Close all doors, Hood, Liftgate, and Trunk |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.