SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018TAHOE LT, 4WD, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER DOOR LOCK SYSTEM AND RELEASE SYSTEM - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSDOOR LOCK SWITCH REPLACEMENT - DRIVER SIDE (CHEVROLET, GMC)
2018 Chevrolet Tahoe LT, 4WD, Gas

Door Lock Switch Replacement - Driver Side (Chevrolet, GMC)

2018 Chevrolet Tahoe LT, 4WD, GasSECTION Door Lock Switch Replacement - Driver Side (Chevrolet, GMC)
Fig 1: Door Lock Switch - Driver Side (Chevrolet, GMC)
GM3632854Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the front side door trim. Refer to Front Side Door Trim Replacement .
1 Door Lock Switch Driver Side Assembly

Procedure

  1. Using a plastic pry tool, gently pry on the sides to release the switch.
  2. Disconnect the electrical connectors.
  3. Refer to Control Module References for programming and set up procedures, if required.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.