Front Side Door Window Weatherstrip Replacement

2018 Chevrolet Tahoe FL, 4WD, GasSECTION Front Side Door Window Weatherstrip Replacement
Fig 1: Front Side Door Window Weatherstrip
GM3617957Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the front side door window. Refer to Front Side Door Window Replacement .
1 Front Side Door Window Weatherstrip

Procedure

  1. Grasp both upper corners of the window weatherstrip, pull downward releasing the assembly from the door frame.
  2. Insert the weatherstrip downward in the front guide until fully seated.
  3. Position the window weatherstrip in the upper rear corner of the frame, work the weatherstrip around the door frame.
  4. Carefully move the regulator upward for short slow intervals, while ensuring that the window remains in the guide.
NOTE:

Inspect the door window for proper operation before installing the door trim.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.