Rearview Driver Information Camera Replacement (Without DRZ)

2018 Chevrolet Tahoe FL, 4WD, GasSECTION Rearview Driver Information Camera Replacement (Without DRZ)
Fig 1: Rearview Driver Information Camera (Without DRZ)
GM3637292Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Liftgate Trim Finish Panel. Refer to Liftgate Trim Finish Panel Replacement
1 Rearview Driver Information Camera

Procedure

  1. Disconnect the electrical connector.
  2. Depress the clip fingers and push outward to remove the camera from the panel.
  3. Calibrate Video Processing Control Module. Refer to Video Processing Control Module Calibration 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.