Rearview Driver Information Camera Replacement (With DRZ)

2018 Chevrolet Tahoe FL, 4WD, GasSECTION Rearview Driver Information Camera Replacement (With DRZ)
Fig 1: Rearview Driver Information Camera (With DRZ)
GM4565921Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Liftgate Trim Finish Panel. Refer to Liftgate Trim Finish Panel Replacement
1 Rearview Driver Information Camera

Procedure

  1. Disconnect the electrical connectors.
  2. Release the retaining tabs.
2 Rearview Driver Information Camera

Procedure

  1. Use a small flat bladed tool to remove the camera.
  2. Calibrate Video Processing Control Module. Refer to Video Processing Control Module Calibration 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.