Radio Antenna Cable Extension Radio End Cable Replacement (Cadillac)

2018 Chevrolet Tahoe FL, 4WD, GasSECTION Radio Antenna Cable Extension Radio End Cable Replacement (Cadillac)
Fig 1: Radio Antenna Cable Extension Radio End Cable (Cadillac)
GM3649062Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel upper trim panel bracket. Refer to Instrument Panel Upper Trim Panel Bracket Replacement (Cadillac) .
  2. Remove the instrument cluster hood. Refer to Instrument Panel Instrument Cluster Hood Replacement (Cadillac) .
1 Radio Antenna Cable Extension Radio End Cable

Procedure

  1. Disconnect the extension cable from the radio antenna cable.
  2. Disconnect the extension cable from the radio.
NOTE:

The cable routes behind the instrument panel carrier and has integral clips that are clipped to the carrier in three places.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.