Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Adding Transmitters (Without SPS)
- Verify all mechanical keys operate correctly before beginning any programming procedures.
- To initiate, this procedure requires that 2 learned transmitters be available.
- A total of eight transmitters can be learned to a single vehicle.
- This procedure adds transmitters only. The procedure does not erase previously learned transmitters.
- Place the recognized transmitters in the vehicle cupholder.
- Insert the mechanical key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position five times within ten seconds. The driver information center will display Ready For Remote #2, 3, 4, etc..
- Place the new transmitter into the transmitter pocket.
- Press and release the ignition mode switch. When the transmitter is learned, the driver information center will indicate that it is ready to program the next transmitter.
- Remove the transmitter from the transmitter pocket and press the transmitter unlock button. To program additional transmitters, repeat Steps 3 through 5.
- When all additional transmitters are programmed, press and hold the ignition mode switch for 15 seconds to exit programming mode.
- Verify each transmitter and key is operating properly. Operate each of the keyless entry functions using the buttons on the transmitter. On vehicles with a keyed ignition switch, verify the mechanical key by starting the vehicle using the ignition switch. When verifying operation, make sure that no other transmitters are near the vehicle.
The transmitter pocket is located inside the center console storage area, near the front of the storage compartment. If a large keyring prevents the transmitter from being placed fully into the pocket, remove the keyring and place the transmitter in the pocket. Failure to lay the transmitter fully into the pocket may result in an inability to program.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.