Remote Control Door Lock Receiver Replacement

2018 Chevrolet Suburban FL, RWD, Gas/EthanolSECTION Remote Control Door Lock Receiver Replacement
Fig 1: Remote Control Door Lock Receiver
GM3637187Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the quarter lower rear trim panel - right side. Refer to Quarter Lower Rear Trim Panel Replacement (Right Side, Standard Wheelbase)Quarter Lower Rear Trim Panel Replacement (Right Side, Extended Wheelbase) .
1 Remote Control Door Lock Receiver

Procedure

  1. Disconnect the electrical connector and the radio antenna extension cable.
  2. Slide the receiver rearward to release.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.