Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SONIC PREMIER, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 96 (OBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEM)REPAIR INSTRUCTIONSFRONT VIEW CAMERA MODULE LEARNNO CALIBRATION
2018 Chevrolet Sonic Premier, 4D Sedan, Standard Trans
No Calibration
2018 Chevrolet Sonic Premier, 4D Sedan, Standard TransSECTION No Calibration
WARNING: This page is about a different car, the 2017 GMC Canyon and 2017 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
Conditions that will prevent completion of the self-calibration procedure:
- Camera not properly installed. Verify it is snapped into tabs and is secure. Refer to Front View Camera Replacement .
- Dirty windshield glass or obstruction on windshield
- Operating the vehicle with speed less than 56 km/h (35 MPH)
- No visible lane markings
- Severe weather where lane markings cannot be seen
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.