Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2018SONIC PREMIER, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSFRONT VIEW CAMERA MODULE PROGRAMMING AND SETUPUNSUCCESSFUL PROGRAMMING RECOVERY
2018 Chevrolet Sonic Premier, 4D Sedan, Standard Trans
Unsuccessful Programming Recovery
2018 Chevrolet Sonic Premier, 4D Sedan, Standard TransSECTION Unsuccessful Programming Recovery
WARNING: This page is about a different car, the 2017 GMC Canyon and 2017 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
In the event of an interrupted or unsuccessful programming event, perform the following steps:
- Ignition ON. Ensure the K109 Frontview Camera Module, DLC and programming tool connections are secure and the SPS software is up to date.
- Verify the K109 Frontview Camera Module can be reprogrammed.
- If the K109 Frontview Camera Module cannot be reprogrammedÂ
- Ignition OFF for 1 min, ignition ON.
- Verify the K109 Frontview Camera Module can be reprogrammed.
- If the K109 Frontview Camera Module cannot be reprogrammed, replace the K109 Frontview Camera Module.
- If the K109 Frontview Camera Module can be reprogrammed.
- All OK.
- If the K109 Frontview Camera Module can be reprogrammedÂ
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.