SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SONIC PREMIER, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS/FUEL - 1.4L (LUV) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSCHASSIS CONTROL MODULE REPLACEMENT
2018 Chevrolet Sonic Premier, 4D Sedan, Standard Trans

Chassis Control Module Replacement

2018 Chevrolet Sonic Premier, 4D Sedan, Standard TransSECTION Chassis Control Module Replacement
GM2745419Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the right rear compartment side trim panel. Refer to Rear Compartment Side Trim Replacement - Right Side (Sedan) .
  3. Disconnect the electrical wiring harness connector from the fuel pump control module.
1 Chassis Control Module Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Chassis Control Module
CAUTION:
  • Turn the ignition OFF when installing or removing the control module connectors and disconnecting or reconnecting the power to the control module (battery cable, powertrain control module (PCM) /engine control module (ECM) /transaxle control module (TCM) pigtail, control module fuse, jumper cables, etc.) in order to prevent internal control module damage.
  • Control module damage may result when the metal case contacts battery voltage. DO NOT contact the control module metal case with battery voltage when servicing a control module, using battery booster cables, or when charging the vehicle battery.
  • In order to prevent any possible electrostatic discharge damage to the control module, do no touch the connector pins or the soldered components on the circuit board.
  • Remove any debris from around the control module connector surfaces before servicing the control module. Inspect the control module connector gaskets when diagnosing or replacing the control module. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the control module.
  • The replacement control module must be programmed.

Procedure

  1. Remove the chassis control module from the module bracket.
  2. If replacing the chassis control module, refer to Control Module References for programming and setup.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.