SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SONIC PREMIER, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WASHER PUMP REPLACEMENT
2018 Chevrolet Sonic Premier, 4D Sedan, Standard Trans

Windshield Washer Pump Replacement

2018 Chevrolet Sonic Premier, 4D Sedan, Standard TransSECTION Windshield Washer Pump Replacement
GM2497851Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the front left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Front)Front Wheelhouse Liner Replacement (Rear)Front Wheelhouse Liner Replacement (with WFK) .
1 Windshield Washer Pump Hose
Procedure 
Place a clean suitable drain pan under the windshield washer pump area to recover the windshield washer solvent when the windshield washer pump hose is disconnected.
2 Windshield Washer Pump

Procedure

  1. Disconnect the electrical connector to the windshield washer pump.
  2. Using two flat-bladed tools, place the blades on each side of the washer pump, under the windshield washer pump grommet.
  3. Twist the two flat-blades in opposite directions to lift the washer pump from the windshield washer solvent container.
  4. Disengage the washer pump from the windshield washer container.
  5. Remove the windshield washer pump and discard the windshield washer pump grommet.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.