Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SONIC PREMIER, 4D SEDAN, STANDARD TRANSREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESREAR WASHER SYSTEM MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2018 Chevrolet Sonic Premier, 4D Sedan, Standard Trans
Circuit/System Verification
2018 Chevrolet Sonic Premier, 4D Sedan, Standard TransSECTION Circuit/System Verification
- Ignition ON.
- Verify the Scan Tool Rear Closure Ajar Switch Parameter changes between Inactive and Active when Opening and closing the liftgate.
- If the parameter does not change
Refer to Door Ajar Indicator Malfunction
- Go to next step: If the parameter changes
- If the parameter does not change
- Verify the scan tool Rear Wiper Switch parameter changes between On and Off when cycling the rear wiper switch ON and OFF.
- If the parameter does not change
Refer to Rear Wiper System Malfunction
- Go to next step: If the parameter changes
- If the parameter does not change
- Verify the G24 Windshield Washer Pump turns on and off when commanding the rear washers OFF and ON with the rear washer switch
- If the Rear Window Washers do not turn ON
Refer to Circuit/System Testing
- Go to next step: If the Rear Window Washers turn ON
- If the Rear Window Washers do not turn ON
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.