Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SONIC PREMIER, 4D SEDAN, AUTOMATIC TRANSREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMSPECIFICATIONSFASTENER SPECIFICATIONS
2018 Chevrolet Sonic Premier, 4D Sedan, Automatic Trans
Fastener Specifications
2018 Chevrolet Sonic Premier, 4D Sedan, Automatic TransSECTION Fastener Specifications
Reusable Threaded Fastener Tightening Specifications
| Application | Specification |
|---|---|
| Metric (English) | |
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
| Front Side Door Window Rear Guide Nut | 11 N.m (97 lb in) |
| Front Side Door Window Regulator Guide Nut | 11 N.m (97 lb in) |
| Front Side Door Window Regulator Motor Screw | 5 N.m (44 lb in) |
| Front Side Door Window Regulator Screw | 11 N.m (97 lb in) |
| Rear Side Door Window Guide Nut | 11 N.m (97 lb in) |
| Rear Side Door Window Outer Sealing Strip Screw | 2 N.m (18 lb in) |
| Rear Side Door Window Rear Guide Nut | 11 N.m (97 lb in) |
| Rear Side Door Window Regulator Motor Screw | 5 N.m (44 lb in) |
| Rear Side Door Window Regulator Screw | 11 N.m (97 lb in) |
| Rear Side Door Window Weatherstrip Lower Bolt | 9 N.m (80 lb in) |
| Rear Side Door Window Weatherstrip Upper Screw | 3 N.m (27 lb in) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.