SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SILVERADO 2500 HD WT, 2D PICKUP, 6.0L ENG VIN G, RWD, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 366 (ANTILOCK BRAKE SYSTEM AND TRACTION CONTROL SYSTEM)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2018 Chevrolet Silverado 2500 HD WT, 2D Pickup, 6.0L Eng VIN G, RWD, Gas

Removal Procedure

2018 Chevrolet Silverado 2500 HD WT, 2D Pickup, 6.0L Eng VIN G, RWD, GasSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. IMPORTANT: The area around the EHCU MUST be free from loose dirt to prevent contamination of disassembled ABS components.
  3. Thoroughly wash all contaminants from around the EHCU.
  4. Disconnect the chassis electrical connectors from the EBCM.
    5. Fig 1: Identifying Chassis Electrical Connectors To EBCM
    GM924296Courtesy of GENERAL MOTORS CORP.
  5. Remove the mounting screws (1) that fasten the EBCM (2) to the BPMV (3).
    6. Fig 2: Removing EBCM To BPMV Mounting Screws
    GM924301Courtesy of GENERAL MOTORS CORP.
  6. Remove the EBCM (2) from the BPMV (3). Removal may require a light amount of force.
    NOTE: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.
    7. Fig 3: Removing EBCM From BPMV
    GM924291Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the BPMV electrical connector from the EBCM.
    8. Fig 4: Disc
    GM924286Courtesy of GENERAL MOTORS CORP.
  8. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.