Front View Camera Replacement

2018 Chevrolet Silverado 2500 HD WT, 2D Pickup, 6.0L Eng VIN G, RWD, GasSECTION Front View Camera Replacement
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Sierra 3500 HD, 2015 GMC Sierra 2500 HD, 2015 GMC Sierra 1500, 2015 Chevrolet Silverado 3500 HD, and 2015 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front View Camera
GM3975606Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary ProcedureΒ 
Remove the windshield multifunction sensor mounting bracket cover. Refer to Windshield Multifunction Sensor Mount Bracket Cover Replacement .
1 Front View Camera

Procedure

  1. Using a suitable plastic tool, insert the tool between the edge of the front view camera retainers, turn the tool to release the retainers and the camera and rotate downward.
  2. Disconnect the electrical connector.
  3. After replacement of the front view camera, program the front view camera. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.