Rear Object Alarm Control Module Replacement

2018 Chevrolet Silverado 2500 HD WT, 2D Pickup, 6.0L Eng VIN G, RWD, GasSECTION Rear Object Alarm Control Module Replacement
WARNING: This page is about a different car, the 2012 GMC Sierra, 2012 GMC Cab & Chassis Sierra, 2012 Chevrolet Silverado, and 2012 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Object Alarm Module And Nuts
GM1708680Courtesy of GENERAL MOTORS COMPANY
Rear Object Alarm Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the front passenger bucket seat. Refer to Front Seat Replacement - Bucket .
1 Rear Object Alarm Module Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Rear Object Alarm Module Assembly

Procedure

  1. Position carpet in order to access module.
  2. Disconnect electrical connector.
  3. Reprogram the module after replacement. Refer to Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.