Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2018SILVERADO 2500 HD WT, 2D PICKUP, 6.0L ENG VIN G, RWD, GASREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSGLOW PLUG CONTROL MODULE PROGRAMMING AND SETUPGPCM REPLACEMENT
2018 Chevrolet Silverado 2500 HD WT, 2D Pickup, 6.0L Eng VIN G, RWD, Gas
GPCM Replacement
2018 Chevrolet Silverado 2500 HD WT, 2D Pickup, 6.0L Eng VIN G, RWD, GasSECTION GPCM Replacement
If the GPCM is replaced, the following procedures must be performed:
- Enable GPCM programming - Refer to Service Programming System (SPS) .
- Refer to Fuel Injector Flow Rate Programming for fuel injector flow rate programming.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.