Remote Control Door Lock Receiver Replacement

2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/EthanolSECTION Remote Control Door Lock Receiver Replacement
Fig 1: Remote Control Door Lock Receiver
GM3269261Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Lower the rear of the headlining trim panel to gain access to the receiver. Refer to Headlining Trim Panel Replacement (Crew Cab Without Sunroof)Headlining Trim Panel Replacement (Crew Cab With Sunroof)Headlining Trim Panel Replacement (Extended Cab)Headlining Trim Panel Replacement (Regular Cab) .
1 Remote Control Door Lock Receiver

Procedure

  1. Disconnect the electrical connector.
  2. Release tabs on receiver to remove from the roof rear header panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.