Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016SILVERADO 1500 SSV, 4WD, PART TIME T/CASE CONTROL, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATOR - WHEELS/VEHICLE UNDERBODY COMPONENT VIEWSWHEELS/VEHICLE UNDERBODY COMPONENT VIEWSCHASSIS COMPONENTS (CHASSIS CAB)
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/Ethanol
Chassis Components (Chassis Cab)
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/EthanolSECTION Chassis Components (Chassis Cab)
Chassis Components (Chassis Cab)
| Items |
|---|
| 1. R6A Terminating Resistor - High Speed Bus R6A Terminating Resistor - High Speed Bus (LC8)R6A Data Link Resistor 1 |
| 2. B150 Fuel Tank Pressure Sensor B150 Fuel Tank Pressure Sensor (-LML) |
| 3. Q13 Evaporative Emission Vent Solenoid Valve (except LML) Q13 Evaporative Emission Vent Solenoid Valve (-LML) |
| 4. K17 Electronic Brake Control Module K17 Electronic Brake Control Module (1500)K17 Electronic Brake Control Module (2500/3500) |
| 5. B195A Nitrogen Oxides Sensor 1 (LML) B195A Nitrogen Oxides Sensor 1 |
| 6. K133 Trailer Brake Power Control Module (JL1) K133 Trailer Brake Power Control Module (JL1) |
| 7. K38 Chassis Control Module K38 Chassis Control Module |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.