Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016SILVERADO 1500 SSV, 4WD, PART TIME T/CASE CONTROL, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSAIR INLET GRILLE PANEL EXTENSION REPLACEMENT (RIGHT SIDE)REMOVAL PROCEDURE
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/Ethanol
Removal Procedure
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/EthanolSECTION Removal Procedure
- Open the hood.
- Remove the radio antenna. Refer to Radio Antenna Replacement .
- Press inward and lift the inside face of the inlet grille panel extension (1) to remove the extension inside tab from the air inlet grille panel (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.