Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2016SILVERADO 1500 SSV, 4WD, PART TIME T/CASE CONTROL, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSFRONT VIEW CAMERA MODULE PROGRAMMING AND SETUPUNSUCCESSFUL PROGRAMMING RECOVERY
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/Ethanol
Unsuccessful Programming Recovery
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/EthanolSECTION Unsuccessful Programming Recovery
In the event of an interrupted or unsuccessful programming event, perform the following steps:
- Ignition ON. Ensure the K109 Frontview Camera Module, DLC and programming tool connections are secure and the SPS software is up to date.
- Verify the K109 Frontview Camera Module can be reprogrammed.
- If the K109 Frontview Camera Module cannot be reprogrammedÂ
- Ignition OFF for 1 min, ignition ON.
- Verify the K109 Frontview Camera Module can be reprogrammed.
- If the K109 Frontview Camera Module cannot be reprogrammed, replace the K109 Frontview Camera Module.
- If the K109 Frontview Camera Module can be reprogrammed.
- All OK.
- If the K109 Frontview Camera Module can be reprogrammedÂ
- All OK.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.