SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016SILVERADO 1500 SSV, 4WD, PART TIME T/CASE CONTROL, GAS/ETHANOLREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEOBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC P15F6: FRONT OBJECT DETECTION CONTROL MODULE TORQUE REQUEST SIGNAL MESSAGE COUNTERDIAGNOSTIC AID
2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/Ethanol

Diagnostic Aid

2016 Chevrolet Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/EthanolSECTION Diagnostic Aid

This is an informational DTC set by the engine control module. It is set to provide an indication that the Frontview Camera Module will not be able to perform as intended. Diagnose any other DTCs first. During normal diagnostic and/or repair verification technicians may find that a "Service Driver Assist System" message may be displayed by the Frontview Camera Module. Do not replace the Frontview Camera Module for this condition.

If the Service Driver Assist System message is displayed with no DTCs set, perform the following steps:

  1. Remove the key from the ignition, open and close the driver's door to turn off retained accessory power, and wait 60 s.
  2. Ignition ON, if the Service Driver Assist message is still present, operate the vehicle at speeds greater than 15 km/h (10 mph) to complete the self test. The Frontview Camera Module should request the message to turn off.
  3. If the telltales remain on with no DTCs set after the drive cycle, disconnect the battery for at least 60 s, then reconnect the battery.
  4. Operate the vehicle at speeds greater than 40 km/h (25 mph), the Frontview Camera Module should request all indicators to turn off.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.