SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LT, 2.5L ENG VIN A, GASREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSKEYLESS ENTRY CONTROL MODULE REPLACEMENT
2016 Chevrolet Impala LT, 2.5L Eng VIN A, Gas

Keyless Entry Control Module Replacement

2016 Chevrolet Impala LT, 2.5L Eng VIN A, GasSECTION Keyless Entry Control Module Replacement
Fig 1: Keyless Entry Control Module
GM2915794Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement
  2. Remove the instrument panel insulator panel - right side. Refer to Instrument Panel Insulator Replacement - Right Side .
1 Keyless Entry Control Module

Procedure

  1. Disconnect the electrical connections.
  2. Slide module downward and release tabs on bracket.
  3. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.