SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTREMOVAL PROCEDURE
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Removal Procedure

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Removal Procedure
  1. Open the hood.
  2. Remove the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  3. Remove the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  4. Remove the sunshade. Refer to Sunshade Replacement .
  5. Lower the front section of the headliner only to access the urethane adhesive bead. Refer to Headlining Trim Panel Replacement (With Sunroof) and Headlining Trim Panel Replacement (Without Sunroof) .
  6. Remove the remote control door lock receiver. Refer to Remote Control Door Lock Receiver Replacement , if equipped.
  7. Remove the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
    NOTE: If the windshield is equipped with a blackout area around the mirror base bracket Care Must be used not to cut or scrape the blackout. If the mount bracket come off the windshield it can Not be reinstalled and the windshield must be replaced. If the bracket is bonded to the windshield it is Not reusable. Remove all sensor, cover, electrical devices and bracket from the pins. If the bracket is bonded to the windshield it is Not reusable.
  8. Remove the windshield garnish moldings left and right side. Refer to Windshield Garnish Molding Replacement .
  9. Cover to protect the following parts from broken glass:
    WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
    • Upper dash pad
    • Defroster outlets and A/C outlets
    • Seats and carpeting
  10. Using the appropriate tool, carefully cut the lace from around the window in order to access the urethane adhesive bead.
  11. Do the following steps when separated the window from the urethane adhesive:
    WARNING: Refer to Glass and Sheet Metal Handling Warning .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.