SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED AND MOVEABLE WINDOW SYSTEMREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW FRAME FRONT APPLIQUE REPLACEMENT
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Rear Side Door Window Frame Front Applique Replacement

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Rear Side Door Window Frame Front Applique Replacement
Fig 1: Rear Side Door Window Frame Front Applique & Fasteners
GM2725301Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the rear side door belt reveal molding. Refer to Rear Side Door Window Belt Reveal Molding Replacement .
  2. Remove the rear side door garnish molding. Refer to Rear Side Door Garnish Molding Replacement .
1 Rear Side Door Window Frame Front Applique Fastener (Qty: 3)
CAUTION: Refer to Fastener Caution .

Procedure

  1. Place the window in the down position.
  2. With the door open, remove the upper front screw attaching the weatherstrip to the door frame.
  3. Use a suitable tool, starting in the upper corner of the door frame pulling the weatherstrip partly out of the front side door frame to access the screws.
2 Rear Side Door Window Frame Front Applique
Procedure 
Work the weatherstrip around the inner door frame, ensure that the weatherstrip is fully seated before operating the window.
NOTE: Inspect the door window for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.