Passenger Window Motor

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Passenger Window Motor
  1. Ignition OFF, disconnect the harness connector at the appropriate passenger or rear M74 Window Motor.
  2. Install a 25 A fused jumper wire between one of the control terminals and 12 V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the M74 Window Motor should perform the UP and DOWN functions.
    • If the function does not perform the UP and DOWN functions 

      Replace the passenger or rear M74 Window Motor.

    • If the function performs the UP and DOWN functions 
  3. All OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.