SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSISBODY & FRAMEEXTERIOR/INTERIOR TRIMINSTRUMENT PANEL AND CONSOLE TRIMREPAIR INSTRUCTIONSFRONT FLOOR CONSOLE REPLACEMENT
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Front Floor Console Replacement

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Front Floor Console Replacement
Fig 1: Front Floor Console
GM2897493Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the front floor console extension - right side. Refer to Front Floor Console Extension Replacement - Right Side .
  2. Remove the front floor console extension - left side. Refer to Front Floor Console Extension Replacement - Left Side .
  3. Disconnect the wiring harness from the access plate.
  4. Remove the access plate fasteners, then the plate from the console.
  5. Disconnect the transmission range selector lever cable terminal from the shift lever pin.
  6. Release the transmission range selector lever cable retainer and remove the range selector cable from the transmission control lever base.
1 Front Floor Console Bolt (Qty: 8)
CAUTION: Refer to Fastener Caution .

Procedure 
Pull back the carpet and insulator to access the fasteners from the floor console.
Tighten 
7 N.m (62 lb in)
2 Front Floor Console Bolt (Qty: 2)
3 Front Floor Console

Procedure

  1. Disconnect electrical connections.
  2. With the aid of an assistant lift the floor console rearward and upward away from the instrument panel assembly.
  3. Transfer all necessary components.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.