Component Testing

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Component Testing
  1. Ignition OFF, disconnect the keyless entry antenna coax cable from the K77 Remote Control Door Lock Receiver and from the T23 Radio Antenna Amplifier.
  2. Test for less than 5 Ω between the coax cable center terminals end to end.
    • If 5 Ω or greater 

      Replace the coax cable.

    • If less than 5 Ω 
  3. Test for less than 5 Ω between the coax cable outer shield end to end.
    • If 5 Ω or greater 

      Replace the coax cable.

    • If less than 5 Ω 
  4. Test for infinite resistance between the coax cable center terminal and the outer shield.
    • If less than infinite resistance 

      Replace the coax cable.

    • If infinite resistance 
  5. All OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.