SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSRADIO CONTROL ASSEMBLY REPLACEMENT
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Radio Control Assembly Replacement

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Radio Control Assembly Replacement
Fig 1: Radio Control Assembly
GM2913584Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the instrument panel upper trim panel cover. Refer to Instrument Panel Upper Trim Panel Cover Replacement .
  2. Remove the instrument panel center trim plate applique. Refer to Instrument Panel Center Trim Plate Applique Replacement .
  3. Remove the instrument panel lower trim plate applique - passenger side. Refer to Instrument Panel Lower Trim Plate Applique Replacement (Driver Side Lower) and Instrument Panel Lower Trim Plate Applique Replacement (Passenger Side Lower) .
  4. Remove the instrument panel center trim pad. Refer to Instrument Panel Center Trim Pad Replacement .
  5. Remove the instrument panel outer air outlet bezel - right. Refer Instrument Panel Outer Air Outlet Bezel Replacement - Right Side .
  6. Remove the instrument panel outer air outlet bezel - left. Refer Instrument Panel Outer Air Outlet Bezel Replacement - Left Side .
1 Radio Control Fasteners (Qty: 6)
CAUTION: Refer to Fastener Caution .
2 Radio Control Assembly

Procedure

  1. Disconnect the electrical connections.
  2. When replacing the radio control assembly, transfer all necessary components.
  3. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.