SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTIGNITION SWITCH/STEERING LOCKWIRING SYSTEMS AND POWER MANAGEMENT - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSIGNITION AND START SWITCH HOUSING REPLACEMENT
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Ignition and Start Switch Housing Replacement

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Ignition and Start Switch Housing Replacement
Fig 1: Ignition & Start Switch Housing
GM2967783Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Turn Signal Switch Bracket Replacement (With BTM)Turn Signal Switch Bracket Replacement (Without BTM)
1 Ignition and Start Switch Housing Bolt
CAUTION: Refer to Fastener Caution .

Procedure

  1. Use a small hammer and chisel to remove the OLD ignition and start switch housing bolt.

    DISCARD the bolt.

  2. Install the NEW ignition and start switch housing bolt and tighten until the bolt head breaks off.
2 Ignition and Start Switch Housing Strap
3 Ignition and Start Switch Housing

Procedure

  1. Disconnect the electrical connector.
  2. Transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.