SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEMREPAIR INSTRUCTIONSSIDE OBJECT SENSING ALERT MODULE REPLACEMENT
2016 Chevrolet Impala LS, 3.6L Eng VIN N

Side Object Sensing Alert Module Replacement

2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Side Object Sensing Alert Module Replacement
Fig 1: Side Object Sensing Alert Module
GM2901480Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Only remove the rear wheelhouse liner fasteners that attach the liner to the rear fascia. Refer to Rear Wheelhouse Liner Replacement
1 Side Object Sensor Module

Procedure

  1. Disconnect the electrical connector.
  2. Depress the retainer tab (arrow) and slide the module out of the retaining bracket.
  3. For programming and set up, refer to Side Object Sensor Module Programming and Setup
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.