Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION AND PEDESTRIAN PROTECTION SYSTEMREPAIR INSTRUCTIONSFORWARD RANGE RADAR MODULE ALIGNMENT
2016 Chevrolet Impala LS, 3.6L Eng VIN N
Forward Range Radar Module Alignment
2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION Forward Range Radar Module Alignment
- Inspect the forward range radar module for damage. Refer to Forward Range Radar Module Inspection .CAUTION: Always use care when handling the forward range radar module and bracket. Improper handling can cause damage to the module or bracket and affect the functionality of the system.
- The alignment of the forward range radar module is performed under the following vehicle conditions:
- With an empty vehicle:
- There shall not be any person in the vehicle
- Specific equipment can remain in the vehicle
- Luggage must not exceed 5 kg (11 lb)
- The vehicle must stand on a flat surface. The level of the ground must not vary by more than +/-7 mm/m. This corresponds to 0.4 degrees, using a water bubble level.
- Vehicle tires must have specified air pressure.
- With an empty vehicle:
- Use a water bubble level (2) to align the forward range radar module vertically as shown in the graphic.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.