Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016IMPALA LS, 3.6L ENG VIN NREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSMEDIA DISC PLAYER PROGRAMMING AND SETUPREPLACE AND PROGRAM CONTROL MODULE OR REPROGRAM CONTROL MODULEWITH REAR SEAT VIDEO ENTERTAINMENT SYSTEM
2016 Chevrolet Impala LS, 3.6L Eng VIN N
With Rear Seat Video Entertainment System
2016 Chevrolet Impala LS, 3.6L Eng VIN NSECTION With Rear Seat Video Entertainment System
- Install the EL-49642 SPS Programming Support Tool.
- Connect a USB drive to the computer.
- Access the Service Programming System (SPS) and follow the on-screen instructions.NOTE: If using a pre-configured USB drive supplied by General Motors, proceed to step 8.
- On the SPS Supported Controllers screen, select Media Disc Player - USB File Transfer and follow the on-screen instructions. If no data has been released for this application this option will not be displayed, proceed to step 10.NOTE: Warehoused parts may not have current software on them. The following step will verify the module has the latest software version.
- Upon completion of the file transfer, remove the USB drive from the computer.NOTE:
- If there are no updates available for USB transfer via SPS, proceed to step 10.
- All existing files on the USB drive will be erased when the new files are copied.
- Ignition ON, infotainment system ON.
- Connect the USB drive to the rear seat USB port in the vehicle.
- The infotainment system will recognize that update files are available. Follow the infotainment display on-screen instructions and select Update when prompted. Programming will take several minutes.
- Upon completion of programming, remove the USB drive. Follow the infotainment display on-screen instructions.
- On the SPS Supported Controllers screen, select Media Disc Player - Programming and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.