SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSRADIO REPLACEMENTINSTALLATION PROCEDURE
2016 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L

Installation Procedure

2016 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Installation Procedure
    Fig 1: Radio Mounting Bracket To Instrument Panel Carrier Screws
    GM639268Courtesy of GENERAL MOTORS COMPANY
  1. Install the radio mounting bracket. Perform the following steps:
    1. Attach the HVAC harness to the radio mounting bracket with the clip.
      2. CAUTION:

      Refer to Fastener Caution .

    2. Install the screws (2) in order to retain the radio mounting bracket (1) to the instrument panel carrier and tighten to 3 N.m (27 lb in).
    2. Fig 2: Radio & Support Bracket Screws
    GM665518Courtesy of GENERAL MOTORS COMPANY
  2. Connect the electrical/audio and antenna cable connectors to the radio.
  3. Install the radio to the support bracket (1).
  4. Align the radio locator tab into the support bracket locator hole.
  5. Install the radio screws (2) and tighten to 2 N.m (18 lb in).
  6. Install the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  7. Calibrate the new radio assembly. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.