Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016EXPRESS 2500 BASE, VAN CARGO, 6.6L ENG VIN LREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASOBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURES (OBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEM)SYMPTOMS - OBJECT DETECTION (OBJECT DETECTION SYSTEM AND PEDESTRIAN PROTECTION SYSTEM)NOTES
2016 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN L
Symptoms - Object Detection (Object Detection System And Pedestrian Protection System): Notes
2016 Chevrolet Express 2500 Base, Van Cargo, 6.6L Eng VIN LSECTION Notes
NOTE:
The following steps must be completed before using the symptom tables:
- Perform the Diagnostic System Check - Vehicle
before using the Symptom Tables in order to verify that all of the following are true:
- There are no DTCs set.
- The control modules can communicate via the serial data link.
NOTE:The rear vision camera does not communicate on the serial data bus.
- Review the system operation in order to familiarize yourself with the system functions. Refer to Object Detection Description and Operation (with rear park assist UD7) Object Detection Description and Operation (with rear camera UVC) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.