Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016CORVETTE Z06, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERING SYSTEMREPAIR INSTRUCTIONSWIRE TO WIRE REPAIR - STEERINGHIGH TEMPERATURE WIRING REPAIRS
2016 Chevrolet Corvette Z06, 2D Coupe, Standard Trans
High Temperature Wiring Repairs
2016 Chevrolet Corvette Z06, 2D Coupe, Standard TransSECTION High Temperature Wiring Repairs
Use the following procedures to perform high temperature wiring repairs:
- Center the high temperature SCT1 shrink tube over the DuraSeal splice sleeve.
- Using the heat torch, apply heat to the high temperature heat shrink tubing.
- Gradually move the heat from the center to the open end of the tubing:
- The tubing will shrink completely as the heat is moved along the insulation.
- A small amount of sealant will come out of the end of the tubing when sufficient shrinkage is achieved.
- Replace any reflective tape and clips that may have been removed during the repair.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.