SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016CORVETTE Z06, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMDATA COMMUNICATION SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE BRACKET REPLACEMENT
2016 Chevrolet Corvette Z06, 2D Coupe, Standard Trans

Body Control Module Bracket Replacement

2016 Chevrolet Corvette Z06, 2D Coupe, Standard TransSECTION Body Control Module Bracket Replacement
Fig 1: Body Control Module Bracket
GM3391378Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the vehicle performance data bracket. Refer to Vehicle Performance Data Recorder Bracket Replacement .
  2. Remove the instrument panel insulator panel - right side. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
1 Body Control Module Bracket Nuts (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten 
9 N.m (80 lb in)
2 Body Control Module Bracket

Procedure

  1. Disconnect the electrical connector of the module.
  2. Transfer components, as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.