SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016CORVETTE Z06, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROLS AND FUEL - 6.2L (LT1, LT4) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL PUMP POWER CONTROL MODULE REPLACEMENT
2016 Chevrolet Corvette Z06, 2D Coupe, Standard Trans

Fuel Pump Power Control Module Replacement

2016 Chevrolet Corvette Z06, 2D Coupe, Standard TransSECTION Fuel Pump Power Control Module Replacement
Fig 1: Fuel Pump Power Control Module
GM3404600Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Remove the rear wheelhouse liner. Refer to Rear Wheelhouse Liner Replacement .
  2. Remove the park brake module harness retainer.
  3. Remove the park brake module fasteners in order to reposition the park brake module. Refer to Electronic Parking Brake Control Module Replacement .
1 Fuel Pump Power Control Module Fasteners (Qty: 2)
CAUTION: Refer to Fastener Caution .

Tighten 
9 N.m (80 lb in)
2 Fuel Pump Power Control Module

Procedure

  1. Disconnect the fuel pump power control module electrical connector.
  2. If replacing fuel pump power control module, program the control module. Refer to Control Module References
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.