Fuel Pump Insulator Replacement (LT1)

2016 Chevrolet Corvette Z06, 2D Coupe, Standard TransSECTION Fuel Pump Insulator Replacement (LT1)
Fig 1: Fuel Pump Insulator (LT1)
GM3393188Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the intake manifold. Refer to Intake Manifold Replacement .
1 Fuel Pump Insulator
WARNING: The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage and possible injury or death.

Procedure 
Lift the fuel pump insulator away from the fuel feed pipe.
2 Fuel Feed Pipe
NOTE: Align the fuel pump insulator with the fuel feed pipe when installing the fuel pump insulator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.