SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016CORVETTE Z06, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS AND FUEL - 6.2L (LT1, LT4) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL FEED INTERMEDIATE PIPE REPLACEMENT - POSITION 2
2016 Chevrolet Corvette Z06, 2D Coupe, Standard Trans

Fuel Feed Intermediate Pipe Replacement - Position 2

2016 Chevrolet Corvette Z06, 2D Coupe, Standard TransSECTION Fuel Feed Intermediate Pipe Replacement - Position 2
Fig 1: Fuel Feed Intermediate Pipe - Position 2
GM3396959Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
  2. Remove the fuel pump insulator. Refer to Fuel Pump Insulator Replacement (LT1)  and Fuel Pump Insulator Replacement (LT4) .
1 Fuel Feed Intermediate Pipe Fittings (Qty:2)
CAUTION: Refer to Component Fastener Tightening Caution .

Tighten 
28 N.m (21 lb ft)
2 Fuel Feed Intermediate Pipe Position 2

Procedure

  1. DISCARD the old fuel feed pipe and install a NEW fuel feed pipe.
  2. Ensure that the high pressure fuel pipe and fuel pump fittings are clean and dry prior to assembly.
  3. Pressure up the fuel system and check for leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.