SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2016CORVETTE Z06, 2D COUPE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMENGINE CONTROLS AND FUEL - 6.2L (LT1, LT4) - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSENGINE CONTROL MODULE REPLACEMENT
2016 Chevrolet Corvette Z06, 2D Coupe, Standard Trans

Engine Control Module Replacement

2016 Chevrolet Corvette Z06, 2D Coupe, Standard TransSECTION Engine Control Module Replacement
Fig 1: Engine Control Module
GM3404882Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedure

  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection .
  2. Front Wheelhouse Liner Replacement
1 Electronic Control Module
WARNING: Refer to Safety Glasses Warning .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.