Assist Step Control Module Scan Tool Information

2015 Chevrolet Tahoe LS, RWDSECTION Assist Step Control Module Scan Tool Information
Scan Tool Data Parameters

Parameter Expected Value Description
Operating Conditions:Β  Ignition ON
Battery Voltage Varies Current voltage of battery.
Assist Step System Status Normal Scan tool displays Unknown, Enabled, Disabled, or Extended.
Driver Door Ajar Switch Door Closed Scan tool displays Door Closed or Door Open.
Passenger Door Ajar Switch Door Closed Scan tool displays Door Closed or Door Open.
Left Rear Door Ajar Switch Door Closed Scan tool displays Door Closed or Door Open.
Right Rear Door Ajar Switch Door Closed Scan tool displays Door Closed or Door Open.
Left Assist Step Learn Status Yes Scan tool displays Learned if the left step learn has been completed.
Left Assist Step Position Count Value Scan tool displays the current left step position count.
Right Assist Step Learn Status Yes Scan tool displays Learned if the right step learn has been completed.
Right Assist Step Position Count Value Scan tool displays the current right step position count.
Right Assist Step Command Retract Completed Scan tool displays Unknown, Extend Completed, Retract Completed, Extending, Retracting, Error, Object Detected, or Timeout.
Left Assist Step Command Retract Completed Scan tool displays Unknown, Extend Completed, Retract Completed, Extending, Retracting, Error, Object Detected, or Timeout.
Assist Step Disable Switch Inactive Displays Active if switch is pressed.
Scan Tool Output Controls

Output Control Description
Left Assist Step Motor Allows scan tool control of left assist step.
Right Assist Step Motor Allows scan tool control of right assist step.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.