Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Control Module Bracket Replacement
2015 Chevrolet Tahoe LS, RWDSECTION Body Control Module Bracket Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the body control module. Refer to Body Control Module Replacement . |
|
| 1 | Body Control Module Bracket Fasteners (Qty: 3)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 2 | Body Control Module Bracket Procedure Release the instrument panel harness retainer, disconnect and unclip the airbag wiring harness connector from the plastic retainer on the body control module bracket. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.