SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015SILVERADO 1500 HIGH COUNTRY, 5.3L ENG VIN C, RWD, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2776 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSRADIO FUNCTION SWITCH REPLACEMENTREMOVAL PROCEDURE
2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, Gas

Removal Procedure

2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, GasSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2017 GMC Sierra 3500 HD, 2017 GMC Sierra 2500 HD, 2017 GMC Sierra 1500, 2017 Chevrolet Silverado 3500 HD, and 2017 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Instrument Panel Accessory Bezel
    GM4632413Courtesy of GENERAL MOTORS COMPANY
  1. Use a flat bladed plastic trim tool in order to release the retainer clips securing the instrument panel accessory bezel (1) to the instrument panel assembly.
  2. Instrument Panel Accessory Bezel (1) - Remove
    3. Fig 2: Radio Control Bolts And Instrument Panel Accessory Bezel
    GM4632417Courtesy of GENERAL MOTORS COMPANY
  3. Radio Control Bolt (1) - Remove
  4. Disconnect the electrical connectors.
  5. Instrument Panel Accessory Bezel (2) - Remove
    6. Fig 3: Radio Control Bracket
    GM4632422Courtesy of GENERAL MOTORS COMPANY
  6. Radio Bracket Bolt (1) - Remove
  7. Radio Control Bracket (2) - Remove
    8. Fig 4: Radio Function Switch
    GM4632434Courtesy of GENERAL MOTORS COMPANY
  8. Radio Bracket Bolt (1) - Remove
  9. Release the retaining tabs.
  10. Radio Function Switch (2) - Remove
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.