Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2015SILVERADO 1500 HIGH COUNTRY, 5.3L ENG VIN C, RWD, GASREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2321 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSENGINE CONTROL MODULE PROGRAMMING AND SETUP (GASOLINE ENGINES)ECM REPLACEMENT
2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, Gas
ECM Replacement
2015 Chevrolet Silverado 1500 High Country, 5.3L Eng VIN C, RWD, GasSECTION ECM Replacement
WARNING: This page is about a different car, the 2012 GMC Sierra, 2012 GMC Cab & Chassis Sierra, 2012 Chevrolet Silverado, and 2012 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
If the engine control module (ECM) is replaced, the following procedures must be performed:
- ECM Reprogramming-Refer to Service Programming System (SPS) .
- Crankshaft Position (CKP) Variation Learn-Refer to Crankshaft Position System Variation Learn , for the V6, Crankshaft Position System Variation Learn , for the V8, or Crankshaft Position System Variation Learn for the Hybrid.
- Theft Deterrent Programming-Refer to Theft Deterrent Module Programming and Setup .
- Brake Pedal Position Sensor Learn-Refer to Brake Pedal Position Sensor Learn .
- Fuel Composition Diagnostic-Refer to Fuel Composition Diagnosis for the 5.3L (LMG or LC9).
- Throttle Learn procedure-Refer to Throttle/Idle Learn , for the V6, Throttle/Idle Learn , for the V8, or Throttle/Idle Learn for the Hybrid.
- Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
- Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.